Konftel 300 - Conference Guide Settings and Status

15
DELETING CONFERENCE GROUPS

Select MENU > CONF GUIDE > ERASE GROUP.

Mark the group you want to delete and press OK.

Conrm that you really want to delete the group by pressing OK or cancel the dele-
tion of a group by pressing C.
DELETE ALL CONFERENCE GROUPS

Select MENU > CONF GUIDE > ERASE ALL.

Conrm that you really want to delete all groups by pressing OK or cancel the dele-
tion of all groups by pressing C.
CONFERENCE GUIDE SETTINGS
When a multi-party call is going to be connected, a special signal (ash or R-pulse) is
produced which transmits the command (request, return and conference) to the PBX.
It may be necessary to change the type of signal if calls are connected via a PBX.
Different PBXs may require different signals. These requirements should be specied
in the technical data for the PBX. Settings for the most common PBXs are listed on
Konftel’s website.

Select MENU > CONF GUIDE > SETTINGS.

Enter the command for a request for a new dialling tone and press OK to conrm.
(“F” is the default setting)

Enter the command to connect everyone to a multi-party call and press OK to
conrm. (“F3” is the default setting)

Enter the command to return to your original call and press OK to conrm. (“F” is
the default setting)
If you experience problems making multi-party calls
It may be necessary to change the duration of the Flash/R-pulse so that it works with
your PBX. Read “ADJUSTING FLASH/R-PULSE DURATION” on page 23.
Your PBX may not be programmed to admit multi-party calls or the procedure may be
different. Please contact your telephone administrator or service provider.
CONFERENCE GUIDE