7-10 bizhub 306/266
Store Address
7
7.2
% For details on the F code such as the SUB address and password, refer to page 4-3.
8 Use the +/, key to select a setting item, then press the OK key.
% The SUB address and password can be specified using up to 20 digits.
% If [SUB, SID SETTING] is selected: Enter the SUB address and password, then press the Back key.
% When [MODEM SPEED] is selected: Use the +/, key to select [33.6Kbps], [14.4Kbps], or [9.6Kbps],
then press the Back key.
% Repeat this procedure until all the required settings are completed.
9 Select [RETURN], then press the OK key.
This returns to the screen where a fax number can be entered.
10 Press the OK key.
This registers settings, and returns to the Store Address screen.
7.2.5 Changing or deleting a speed dial destination
1 Press the Utility key.
2 Use the +/, key to select [DIAL REGISTRATION], then press the OK key.
3 Use the +/, key to select [SPEED DIAL], then press the OK key.
4 Enter a target 3-digit speed dial number using the Keypad, then press the OK key.
5 Use the +/, key to select [EDIT] or [DELETE], then press the OK key.
% If [EDIT] is selected, go to the next step.
% If [DELETE] is selected, the information registered in the One-Touch Dial Key is deleted, and the
display returns to the Store Address screen.
6 Change the destination name, fax number, F code (SUB address or password), or baud rate.
After all settings are completed, the display returns to the Store Address screen.
dReference
For details on how to change each setting, refer to Steps 6 to 8 in page 7-7.
To Next Page
Loading...
Need help?
General
