bizhub 367/287/227 3-19
3.2 Scan-to-Send function
3
Basic Settings and Operations Chapter 3
- In general, the default settings are available for network connection; however, some network environ-
ments require a change on network settings.
- If no IP address is displayed, you need to configure the network. Tap [Utility], and select [Administrator
Settings] - [Network Settings] - [TCP/IP Settings]. Configure the required settings to suit your environ-
ment. For details, refer to the User's Guide CD.
- For information on the default administrator password, refer to page 5-50.
Checklist
While making notes in the checklist shown below, check computer information and configure settings for
preparation. The completed checklist is used for Store Address.
Checking computer information
Check the host address and user ID, and write them down.
Name Entry column Detail
Host Address Host name or IP address to which the scanned data is sent page 3-19
File Path Name of the dedicated folder to receive the scanned data page 3-20
User ID User name required to log in to the computer page 3-19
Password Password required to log in to the computer
• You should not enter this column for security reasons.
Contact your sys-
tem administra-
tor.
To Next Page
General
