bizhub C652/C652DS/C552/C552DS/C452 2-52
2.16 Sending scanned data to the user's E-mail address (Scan to Me)
2
2.16.2 User Authentication
Configure settings to restrict users who use this machine.
When the MFP authentication is selected
When the MFP authentication is selected, do the following.
- Configure the settings required for the MFP authentication
- Register the E-mail address of each user when registering users
For details on the settings for the MFP authentication and user registration, refer to page 2-129.
When the Active Directory authentication is selected
When the Active Directory authentication is selected, do the following.
- Configure the settings required for the Active Directory authentication
- Register the E-mail address of each of the users from this machine with the server to enable this
machine to obtain the address using the LDAP protocol
For details on Active Directory authentication settings, refer to page 2-137.
When the NTLM or NDS authentication is selected
When the NTLM or NDS authentication is selected, do the following.
- Configure the settings required for the NTLM or NDS authentication
- Register the E-mail address of each user in User Registration
For details on NTLM authentication settings, refer to page 2-142.
For details on NDS over IPX/SPX authentication settings, refer to page 2-146.
For details on NDS over TCP/IP authentication settings, refer to page 2-149.
2.16.3 E-mail Transmission (SMTP)
Configure settings to send an E-mail.
For details, refer to page 2-43.
2.16.4 SMTP over SSL/Start TLS
Configure the settings for SMTP over SSL or Start TLS.
For details, refer to page 2-45.
2.16.5 SMTP Authentication
Configure SMTP authentication settings.
For details, refer to page 2-47.
2.16.6 POP before SMTP
Configure the settings for POP before SMTP.
For details, refer to page 2-47.
2.16.7 POP over SSL
Configure the settings for POP over SSL.
For details, refer to page 2-49.
To Next Page
Loading...
Need help?
General
