bizhub PRO 1050/1050P
1050e/1050eP
4. SERVICE
199
Field Service Ver3.0 Nov.2006
4.4.4 Initialization
To make use of "Mail remote notification system", it is necessary to register the network parameter on the copier
main body and the account on the mail server.
A. Setting from the touch panel
Set the IP address of the copier from the touch panel to connect the copier to the network. When already set,
proceed to "(2) Setting from the Web browser".
(1) Procedure
NOTE
• The IP address of the copier is normally assigned by the system administrator. For particulars,
contact the system administrator.
B. Setting from the Web Utilities
Enter the setting of the mail server from the Web Utilities. To use the Web Utilities, make preparations of a PC
that can be connected to the network.
NOTE
• No space is available in all items to be set. The following characters cannot be used for setting an
E-mail address.
( ) < > ; : “ [ ]
When an improper entry or setting is made on the Web browser, be sure to make corrections fol-
lowing the error massage. When no correction is made, a down load error of the program may
result.
• The Web layout is subject to change without notice.
Step Operating instructions
1 Select [Utility/counter] on the operation board.
2 Select "06 Machine Manager Setting."
3 Select "04 Network Setting."
4 Select "01 Machine NIC Setting."
5 Enter "IP address," "Subnet mask," and "Gateway Address."
6 Restart the copier.
To Next Page
Loading...
Need help?
General
