10
Specifying management settings
10-42 200/250/350
Specifying administrator forwarding settings (mode 198)
You can specify whether a received document is forwarded to a destination
specified by the administrator.
Factory settings
Specifying settings
The shaded cells represent the factory settings. The page numbers on the
right refer to the descriptions of the corresponding functions.
(*) Bit 7 of mode 198 is enabled only when “1 (transmit)” is specified.
Bit 7654 3210
Setting 1101 0000 (HEX: D0)
Bit Description Setting Description Page ref-
erence
7 Specifies whether a received
document is forwarded to a
destination specified by the
administrator.
0 Not forwarded page 10-2
7
1 Forwarded
6 Specifies whether to enable
TX Forwarding when scan-
ning.(*)
0Not forwarded
1 Forwarded
5, 4 Specifies the print condi-
tions of transmission reports
for TX Forwarding.(*)
00 Not output
01 Undeliverable
10 Always prints
11 *Do not specify these set-
tings.
3,2,1,0 -----------------------------
0000
*
Do not change these bits. ---------
To Next Page
Loading...
Need help?
General
