CHARGINGTHEBATTERY
Before the camera can be used, the lithium-ion battery must be charged. Before charging the
battery, read the safety warnings on page 4 of this manual. Only recharge the battery with the
supplied battery charger. The battery should be recharged before each shooting session. See page
140 for battery care and storage.
Plug the power cord into the back of the charger unit (1). Plug
the other end of the cord into a live household outlet. The
included AC cord is designed for the current of the sales region.
Only use the cord in the region it was purchased. For more on
the AC cable, see page 113.
With the battery contacts toward the charger, align the channels
on the bottom of the battery with the tabs on the charger unit.
Slide the battery into the unit.
The indicator lamp (2) glows to show the battery is charging. The
lamp goes out when the battery is charged. Charging time is
approximately 150 minutes.
Slide and lift the battery to remove it from
the charger. Unplug the power cord
from the outlet.
iNSTALLiNGANDCHANGINGTHEBATTERY
This digital camera uses one NP-400 lithium-ion battery. Before using the battery, read the safety
warnings on pages 4 of this manual. When replacing batteries, the camera should be oft.
1. Open the battery-chamber door by sliding the battery-chamber release toward the back of the
2,
3.
4.
camera.
Insert the battery with the battery contacts first. Push the battery into the chamber until the
battery latch clicks into place.
To remove a battery, slide the battery latch to the side of the battery chamber; the battery
springs out.
Close the battery-chamber door until it clicks shut.
To Next Page
Loading...
Need help?
General
