FOLDERNAME
All recorded images are stored in folders on the memory card. Folder names
come in two formats: standard and date.
Standard folders have an eight character name. The initial folder is named
100KM028. The first three digits are the folder's serial number, which increases
by one each time a new folder is created. The next two letters refer to Konica
Minolta, and the last three numbers indicate the camera used; 028 indicates a
Dynax 5D.
100KM028
(Standard)
A date folder name also star_s with the three digit serial number and is followed
by one register for the year, two register for the month, and two registers for the
day: 100YMMDD. The folder 10150801 was created in 2005 on August 1st.
With the date folder format selected, when an image is recorded a new folder
with the day's date is created. All images recorded that day are placed in that
folder. Images recorded on a different day are placed in a new folder with the
corresponding date. When a new folder is created, the serial number in the
image-file name is reset to 0001 unless file number memory is active. For more information on
folder organization and file names, see page 120.
10150801
(Date)
SELECTFOLDER
This option specifies in which folder images are saved. Only
folders with a standard folder name can be selected. If the date
folder name option is used, images are placed in a folder with the
corresponding date of recording. Select folder is in section 2 of the
setup menu (p. 98).
NEW FOLDER
This allows the creation of new folders. The folder-name option in
section 2 of the setup menu specifies the folder-name format. If
multiple date-format folders are created, only the last folder can be
used for storing images.
Highlight "Enter" and press the center of the controller to create a
new folder.
The new folder name is displayed briefly. Every time a new folder
is created, the folder number increases automatically by one
greater than the highest folder number on the memory card.
LCDBACKLIGHT
The LCD monitor backlight turns off to conserve power after a
certain period. Press a camera button to restore the display. This
period can be set to 5, 10, 30, or 60 seconds in section 3 of the
setup menu (p, 98).
AUTOPOWERSAVE
The camera shuts down to conserve battery power if no operation is made within a certain period.
The length of this period can be changed to 1, 3, 5, 10, or 30 minutes. To restore power, press the
shutter-release button partway down. When the camera is connected to the computer, the auto-
power-save period is set to ten minutes. This period cannot be changed.
To Next Page
Loading...
