CONNECTINGTOWINDOWS98 / 98 SECONDEDiTiON
The driver needs only to be installed once. If the driver cannot be installed automatically, it can be
installed manually with the operating system's add-new-hardware wizard; see the instructions on
the following page. During installation, if the operating system requests the Windows 98 CD-ROM,
inset it into the CD-ROM drive and follow the accompanying instructions on the screen. No special
driver software is required for other Windows operating systems.
Automatic _nstaHatiol_
i ;i i ; ;,;}i _i ii; ,}
iiiiiiiiih_
iiiiiiiiiiii_
iiiiii_
iiiiiiiiii!iii
Before connecting the camera to the
computer, place the Digital Camera
Software CD-ROM in the CD-ROM drive.
The Digital Camera Software installer
launcher opens. To automatically install
the Windows 98 USB driver, click on the
"Install the Windows 98 USB mass-
storage driver" button. A window appears
to confirm that the driver should be
installed; click "Yes" to continue.
When the driver has been successfully
installed, a window appears. Click "OK."
Restart the computer before connecting
the camera (p. 115).
Manua_i[_staHation
To install the Windows 98 driver manually, follow the
instructions in the connecting-the-camera-to-a-computer
section on page 115.
When the camera is plugged into the computer, the
operating system will detect the new device and the add-
new-hardware-wizard window opens. Place the Digital
Camera Software CD-ROM in the CD-ROM drive. Click
"Next."
Choose the recommended search for a suitable driver.
Click "Next."
Choose to specify the location of the driver. The browse
window can be used to indicate the driver location. The
driver should be located in the CD-ROM drive at
:\Win98\USB. When the location is shown in the window,
click "Next."
To Next Page
Loading...
