iNSTANTPLAYBACK
After an image is captured, it can be displayed on the monitors for
two, five, or ten seconds before being saved. The last image of a
continuous-advance or continous-advance bracketing series is
displayed. Instant playback is activated and the length of the
playback period is set with the instant-playback option in section 1
of the recording menu (p. 70).
During the instant playback period, many of the playback functions
are available. The displayed images can be deleted using the
delete button (p. 36). An images can be magnified with the enlarge
button (p. 38). The information display can be turned off and on
with the display button, and the histogram can be displayed using
the up key of the controller (p. 35). When using continuous
advance or continuous-advance bracketing, use the left/right
controller keys or turn the control dial to display the frames in the
series; playback mode is active and all images on the memory
card can be viewed and the playback menu opened.
Display button
Delete button
Enlarge button
Press the shutter-release button par_way down or press the playback button to return to the
recording mode.
NOISEREDUCTION
This function reduces the affect of dark noise with exposures of
one second or longer. Processing is applied to each image after it
is captured. The monitor remains blank during processing for a
maximum of 30 seconds. This can be turned off in section 1 of the
recording menu (p. 70). Noise reduction uses dark-frame
subtraction. Noise reduction is not applied to a continuous-
advance series.
FLASHMODES
The flash mode can be changed in section 2 of the recording
menu (p. 70). For the flash to fire, the built-in unit must be
manually raised; lower the flash to prevent it from firing. The
auto-white-balance setting gives priority to the flash's color
temperature. If another type of white balance is used, priority is
given to the active setting's color temperature.
Fill-flash - used as the main or SLpplementary light
In low-light conditions the flash acts as the main
source of _llumJnatton and overpowers the ambient
light. Under strong sunlight or in backlit situations.
tne fill-flash can reduce harsh shadows.
Red-eye reduction - used when taking photographs of people or animals in low-light
conditions. The red-eye effect is caused by lignt reflected from the retina of the eye. The
camera fires several pre-flashes before the main flash burst to contract the pupils of the
suuject's eyes.
Rear flash sync - used with long exuosures to
make trailing lights or blurring appear to follow rather
than uroceed the subject. The effect is not apparent
if the shutter speed is too fast and sious the
subject s motion.
When the shutter is released, a pre-fiash fires. This
pre-flash is not for exuosure, but for metenng. The
flash fires aga n just before me shutter closes.
Wireless / Remote flash - allows the camera to control an off-came'a flash unit without
the need of a cable. See page 76.
To Next Page
Loading...
