13
Maintenance
Put the door on the lower hinge vertically, and validate the gas tightness of the door gasket. Take out
the spare upper left hinge and hinge cover from the accessory bag, then install the upper left hinge by
tting screws. Finally, install the hinge cover, and cover the hinge hole cap on the upper right side.
Cleaning
Dust behind the upright freezer and on the ground shall be timely cleaned to improve the cooling ef-
fect and energy saving.
Check the door gasket regularly to make sure there are no debris.
Clean the door gasket with a soft cloth dampened with soapy water or diluted detergent.
The interior of the upright freezer should be cleaned regularly to avoid odor. Please turn off the power
before cleaning the interior, remove all foods, drinks, shelves, drawers, etc.
Use a soft cloth or sponge to clean the inside of the refrigerator with two tablespoons of baking soda
and a quart of warm water. Then rinse with water and wipe clean. After cleaning, open the door and
let it dry naturally before turning on the power.
For areas that are dicult to clean in the upright freezer (such as narrow sandwiches, gaps, or cor-
ners), it is recommended to wipe them regularly with a soft rag, soft brush, etc., and when necessary,
combine with some auxiliary tools (such as thin sticks) to ensure no contaminants or bacteria accu-
mulation in these areas.
Do not use soap, detergent, scrub powder, spray cleaner, etc., as these may cause odors in the interior
of the upright freezer or contaminated food.
Clean the bottle frame, shelves, and drawers with a soft cloth dampened with soapy water or diluted
detergent. Dry with a soft cloth or dry naturally.
Wipe the outer surface of the upright freezer with a soft cloth dampened with soapy water, detergent,
etc., and then wipe dry.
Do not use hard brushes, clean steel balls, wire brushes, abrasives (such as toothpastes), organic
solvents (such as alcohol, acetone, banana oil, etc.), boiling water, acid or alkaline items, which may
damage the cooler surface and interior. Boiling water and organic solvents such as benzene may de-
form or damage plastic parts.
Do not rinse directly with water or other liquids during cleaning to avoid short circuits or affect electri-
cal insulation after immersion.
Please unplug the upright freezer for defrost and cleaning.
Defrost
The upright freezer shall be manually defrosted. Disconnect the plug from the wall socket, open the
door and remove all the food to a cool place. It is recommended to remove the frost by a plastic
scraper, or let the temperature rise naturally until the frost melts. Then wipe away the remaining ice
and water, and plug in the socket for switching on the freezer.
Other mechanical devices or other means shall not be used to accelerate except those recommended
by the manufacturer. Do not damage the refrigerant circuit.
To Next Page
Loading...
