Korg Beat Boy - Page 39

39
Be sure to only format using the Beat Boy.
If the Beat Boy is formaed using the
computer, it may not run properly.
Formatting while using USB power
1. Turn o the power to the Beat Boy.
2. Press and hold down the A-B/DELETE
buon and the REC buon while using
a USB cable to connect the Beat Boy to
a computer.
The Beat Boy enters format mode. The
following screen will appear on the display.
To cancel the formaing procedure, press
the buon.
3. Press the buon to format.
While formaing, the following screen
will appear on the display, and the three
indicators of the tuning guide will blink
sequentially in red.
Blinking red
4. When the formatting procedure is
complete, a screen instructing you to
disconnect the unit from the computer
will appear on the display.
)
Page 37 “Disconnecting the Beat Boy from
the computer”
5. Disconnect the Beat Boy from the
computer.