Korg Beat Boy - Included Rubber Feet; Installing Batteries

9
Included rubber feet
If needed, you can aach the included rubber
feet to boom of the Beat Boy.
Installing batteries
Removing the baeries during a recording
will cause the recording to error. Do not
remove the baeries while the Beat Boy is
being used. Always replace the baeries
aer a recording is stopped.
1. Slide the baery compartment cover on
the back of the Beat Boy in direction “a”
as shown in the illustration and li up
the cover in direction “b.”
2. Insert the batteries, making sure to
observe the correct polarity.