Appendix
151
TroubleshootingMessagesAbout the CDRW-1D1200 specificationsEffect Program ListRhythm Pattern ListIndexBlock diagramMIDI implementation
chart
5. Using the CDRW-1
For details on how to back up and restore using the CDRW-
1, and how to use the CDRW-1 to create an audio CD, refer
to “Operation.”
When using the CDRW-1, you must operate the unit in
a level position in a location that is not subject to vibra-
tion.
Playing back an audio CD
Here’s how to play back an audio CD and listen to it
through your headphones or monitor speakers.
1 Connect headphones to the [PHONES] jack or monitor
speakers to the [MONITOR OUT L/R] jacks, and turn
down the level knobs for each jack to the minimum vol-
ume.
2 Insert an audio CD in the CDRW-1.
Press the eject button of the CDRW-1, open the disc tray,
and insert the audio CD.
3 Play back the audio CD.
Access the [CD] “CDR/RW” tab page. Use the cursor to
select the CDR/RW transport key, and
press the [ENTER] key.
4 Press the “CD Monitor” button, and gradually raise the
[PHONES] or [MONITOR OUT L/R] volume level.
Recording the sound of an audio CD
Here’s how to assign the L channel of an audio CD to
track 1, the R channel to track 2, and record the sound of
the CD.
1 Insert an audio CD in the CDRW-1.
2 Assign the audio output from the CDRW-1 to tracks 1
and 2.
Access the [INPUT/OUTPUT/SOLO] “Ch1-6” tab
page, select the “Ch1” icon, and use the [VALUE] dial to
select “CD L.”
In the same way, select the “Ch2” icon and select “CD
R.”
3 Specify the recording tracks.
Press the [TRACK STATUS] keys of tracks 1 and 2 to
select REC.
4 Check the recording mode.
Access the [BOUNCE] “RecMode” tab page. Set “Selec-
tRecMode” to “Input.”
5 Press the [REC] key to enter record-ready mode.
6 Play back the audio CD.
Access the [CD] “CDR/RW” tab page. Use the cursor to
select the CD-R/RW transport key, and
press the [ENTER] key.
7 Press the [PLAY] key to begin recording.
8 When you are finished recording, press the [STOP] key.
9 Stop the audio CD.
Access the [CD] “CDR/RW” tab page. Move the cursor
to the CD-R/RW transport key, and
press the [ENTER] key.
0 Play back the song, and verify that it was recorded cor-
rectly.
The beginning of recording on the D1200 is not synchro-
nized with the beginning of playback of the CD in the
CDRW-1. This means that the above method cannot be
used to record the very beginning of the audio CD. If
you want to record from the beginning of a song, make
Trigger settings before step 4 of this procedure.
(→p.54)
About the CDRW-1
To Next Page
Loading...
