R e latio n sh ip betw ee n the so u n d start/length a n d the
loop start/length se ttings.
M When loop is off.
Plays once from A to B,
• To prevent loop start from affecting loop length, the
longer the loop length, the less room you will have lo
adjust the loop start.
Actual sound length
Rangti over which loop stari may toe adjusted
o
SO U N D
START
SO U N D
l e n g t h
e -
B
H
EN D
■ When loop is on.
Plays A to C to D, then loops C to D, C to D, etc.
(Loops from C to D)
SO U N D
ST A R T
I
--------
0 A
LOOP
L 0 0 P L E N G T H
ST A R T I
©
------
j
C D EN D
Plays A to D. then loops C to A to D, C to A to D t etc.
(Loops from C to D)
ü
LO OP
ST A R T
- T
c
LOOP
LENGTH
________
L -
SO U N D S T A R T
- Ô — —
A
H
EN D
As shown in the diagrams, if loop is on, then play
always starts at sound start (A), goes to the point
specified by loop start plus loop length (D), then loops
back from loop start (C) to the end of the loop length.
The loop is then repeated. Therefore, it is not allow
able to have (A) further to the right than (D), nor to
have (D) further to the right than the end of the sound
(END).
• Loop start plus loop length can not extend further to
the right than the end of the sound. Changing loop
start does not cause a change in loop length, so loop
start can be moved to the right no farther than the
solid dot in the diagram. Furthermore, loop start can
be moved to the left only so far as the sum of loop
start and loop length coincides with the sound start
position.
If loop start is moved tc the right
i---------------
--
• For the same reasons, you can not move sound
start further to the right than the sum of loop start and
loop length (the solid dot in the diagram).
L . S s S
I___________£ = 2 ^
__________
If sound start is moved
lo the right.
, L I
+>-— —
-
ib
-----
L .S S S
171
MULTISOUND MODE
To Next Page
Loading...
