Korg DSS-1 - Page 174

MULTISOUND MOPE
h
Use the cursor keys to select the zero cross
point.
c u r s o r
HC>
Use to select
Zero cross point
• Select the zero cross point using the cursor keys
1
I
You can use the cancel key to return to manual
operation.
OEL/CANCEL
Press [ = =
Sliows you can return to manual operation usine) the cancel key
I
I
I
This lets you repeat from step 2 , setting the loop start
and length parameter values.
j
■ When you are in the manual operation, you can use
the C O M P A R E key to make comparisons between
the effects of newly assigned and previous settings.
i)
Pressing the C O M P A R E key once recalls the setting
that existed previously (that which appeared immedi
ately upon selecting the Loop Start & Length func
tion). _
! COMPARE
Press
Recalls the setting that existed previously.
U
■ ■ -.Hi-nH 1
¡ a p a a O “ • I t # m
P
it) Press the C O M P A R E key again to bring back the new
setting.
Press
* Repeating the above two steps (that is, repeatedly
pressing the C O M P A R E key) lets you compare the ef
fects of the new setting with the previous setting.
• Brings back the new setting.
1“'
i
"x
ib
Lbd +
I
UUP
0 0 0 1 2 : 1 .
i r-L if"«
x r - x ' J j
X d » + b S b A * a X ! " n a i
174