MULTfSOUND MODE
LO OP
ST A R T
LO OP
ST A R T
■ This takes the portion from the start of the loop ad
dress up to about half of the loop length, reverses the
waveform and uses it to replace the remaining length
of the end of the sound waveform. This also assumes
that a sound has been selected from a multisound us
ing F1 and that you have used F6 to specify the loop
start and length parameters.
B. The back-and-forth function.
LOOP L E N G T H
LO O P LEN G T H
■ Before executing a "back & forth” the data from the
loop region is evacuated to the remaining free area of
wave memory. Therefore, the back & forth operation
can not be carried out if remaining area is shorter
than loop length.
LOOP
ST A R T
LO OP
LE N G T H
Remaining area
M.S.02
« + ,
M .S.XX
, +
L
5.01
L
Evacuation
Restoration
■ The evacuated data can be put back in its original
position, thereby restoring the original sound. This is
possible only if done immediately after the back &
forth operation is executed.
176
To Next Page
Loading...
