PROGRAM PARAMETER MODE
F01 WRITE/RENAME
1 About the write/rename function
■ This lets you take the program created in the program
output buffer and write it to a program memory
number of your choice.
Note: i
If you go to the play mode after only renaming and 1
not writing, the new program name will still be [
displayed. However, please remember that this t
name applies only to the program in the program i
output buffer. Do not make the mistake of assuming !
that this has been written to program memory. !
PROGRAM OUTPUT BUFFER
i
PRO G RAM -M EM
2 Using the write/rename function
Operation
o Select the PR O G R A M PA R A M ET E R mode.
Press 0 then 1, or use DATA EN TRY A to select
the write/rename function.
DATA EN TR Y A
o
]
Or li , press
Operation of DSS-1
• Indicates P RO G RA M PA R A M ET ER mode.
PFHHaltAM PA.MAMt’ IN*
& On
• The display prompts you to choose a function.
You are asked if you want to rename.
Shows the program name to rename.
i
■ i u i f . . «a a p
yl Naroe^b.ht'Ul
k 0 T Ì 3 ! vii=:‘ V >
J
To Next Page
Loading...
