Korg DSS-1 - Page 226

PROGRAM PARAMETER MODE
2 ¡Using the VCA EG (attack, decay, slope) function.
■ Press 4 then 5, or use DATA EN T RY A to select the
function.
■ Use the cursor keys to select parameters. Use DATA
ENTRY B to adjust their values.
Display of the VCA EG (attack, decay, slope) function.
Attack value Decay value. Slope value,
F46 VELOCITY SWITCH
i About the velocity switch function.
■ This lets you switch between the multisound assign-
ed to oscillator-1 and osciilator-2 according to how
hard you play the keyboard. Therefore, you can
switch sounds merely by changing the way you play
(assuming that you have different multisounds
assigned to the two oscillators). To obtain completely
different sounds, the F14 mix ratio should be set to
100% vs. 0 % (or vice versa).
The velocity switch function value determines how
hard you have to play to make the switch.
Possible velocity switch values.
I
0 0 -3I
M u ltiso u n d
sw itch level
Effect
oo No switch. Function is off.
0 l Switches even if you play softly,
31
Does not switch unless you play
hard.
■ This function exchanges the oscillator multisounds
assigned by F12 and F13. it does not change the F16
oscillator octave, F15 oscillator-2 detune & interval,
F14 mix ratio, or other settings pertaining to the
volume, mix ratio, or other aspects of oscillator
operation.
As an example, if we have piano at 16' and strings at
S ' with a 7 0 % to 3 0 % mix ratio, then after the
switch we will have strings at 16' and piano at 8 ' with
a mix ratio of 7 0 % to 30%.
F12 0SC1
MULTI SOUND
Piano
70%
I
__________________ .
0SC2
Strings ^
OCT 8’
F13 0SC2
MULTI SOUND
VCF
F11 0SC OCT F14 MIX RATIO
Switch only
affects this
part of chain.
No change here,