Korg DSS-1 - Page 249

F4 GET PROGRAM
1 About the get program function
■ This gets a program from a system on disk and loads
it into the program output buffer.
■ Within this function you can write the loaded program
to any program memory number that you like.
Note:
The program name displayed in the play mode is
the name of the program currently in the program
output buffer. Therefore, if at this point you go to the
play mode without writing, the name of the program
that you got will be displayed but will not have been
written to the program memory.
Example:
1. Select program change POI; "P O T A ”
2. In the system mode, get program name "B ” but don't
write it.
3. Display just after going to the play mode: "PQ1:B"
4. Select program change P01: “PO TA”
(In step 4, the contents of the program output buffer
were changed to A. Program B was lost in the process.
PROGRAM OUTPUT BUFFER
2 Using the get program function
Operation
Operation of DSS-1
® Confirm the SY ST E M mode.
• Indicates SY ST E M mode.
SYSTEM
----- On
CD Put in the disk that has the program that you
wish to load. Press the number 4 key.
4
• The display shows the default values for system and
program parameters.
Press
Shows the get program function.
F4 . GET"PROGRAM
SVSTEMsS PROGRAM:SI
ENTER
T
Flashes.— Shows you can select a program.
249
SYSTEM MODE