■ The mix function (iv) lets you mix together two
sounds* You can determine the ratio of the mixture
and detune them if you like.
For exam ple, you can m ake a fat, phased sound by
mixing a sound with a detuned copy of itself. Both
sounds should be sufficiently long to get this effect.
This is useful for making strings and brass ensemble
sounds.
• The mix function
Example: aquare wave plus sawtooth
— , wave
Example: Grass plus strings
■ The view/edit sample data function (iv) gives you ac
cess to wave memory where you can adjust the level
of each sample of a waveform* Note that each sample
is stored at an address, in sequence from the begin
ning of the sound to the end. You specify the ad
dress, check the current value (signal level at that
sampled point), and make adjustments as you like.
• View/edit sample data function
Wave memory
values
Addresses
t ? ▼
? t
f t
T ?
0 3 5
CO
9 9 8 5 | 1 -3
-6 -7
-8 -8 -7 -4 -1
2
8
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19
You specify the address and can then change the value to
change the sound.
37
To Next Page
