Basic functions 19
Note: When selecting the Layer mode, the total number of voices that can play at
the same time is reduced, depending on the total number of oscillators used by the
selected sounds.
Note: You can’t select two sounds included under the same sound selection button.
1 Press one of the sound selection buttons in order to select the first sound. The LED
on the button you pressed will light. Use the SOUND BANK button to select a
sound in one of the other banks.
2 Press another sound selection button to select the second sound. The LED on the
button you pressed will light. Use the SOUND BANK button to select a sound in
one of the other banks.
3 Press both buttons at the same time to select the sounds. Both LEDs will light.
Note: Steps 1 and 2 are not required, if the right banks are already selected.
Returning to the Single mode. To return to the Single mode, just press a single
sound selection button.
Adjusting the volume of sounds in Layer mode. To adjust the balance bet-
ween the sounds in Layer mode, hold down the button of the sound whose level you
wish to decrease, and repeatedly press the button of the sound whose level you wish
to raise.
Note: This setting will remain memorized even after turning the Layer mode off. It
will be recalled the next time you select the same layered sounds.
Choosing the reverb and the chorus
The EC350 has two effects: reverb and chorus. The reverb simulates the sound
reverberation in a room, while the chorus simulates a modulating effect that makes
the sounds richer.
The last effect settings for a given sound are remembered even when selecting a dif-
ferent sound. If you select another sound (or power off the instrument), your set-
tings are recalled when you return to the sound you edited.
Note: Effect settings made in Single mode are memorized even when selecting the
Layer mode, but no change made in Layer mode will be preserved.
MEMMEM
MEMMEM
To Next Page
Loading...
