Korg EC350 - Control Change Message Functions

40 Chapter 7
Program Change enable/disable. To transmit and receive this kind of data, you
must enable Program Change messages transmission and reception. Otherwise, you
can disable Program Changes data.
Hold down the TRANSPOSE/FUNCTION button, and press the PIANO 2 sound
selection button. Each time you press the switch, the setting will alternate between
Enabled and Disabled.
Control Change
When you operate the damper pedal, adjust the balance in Layer mode, or make
other adjustments on the control panel, a Control Change message is sent to a con-
nected external MIDI device. At the same time, EC350 can receive a Control
Change message from an external MIDI device connected to its MIDI IN, to control
the damper pedal, volume adjustment, and other data.
Control Change enable/disable. To transmit and receive this kind of data, you
must enable Control Change messages transmission and reception. Otherwise, you
can disable Control Changes data.
Hold down the TRANSPOSE/FUNCTION button, and press the E.PIANO 1 sound
selection button. Each time you press this button, the setting will alternate between
Enabled and Disabled.
24
STRINGS/PAD
1 Strings
25 2 Slow Strings
26 3 Warm Pad
27
CHOIR
1 Choir Hoo
28 2 Choir Doo
29 3 Choir Pad
Program Change status PIANO 2 LED status
Enable Lit
Cancel Dark
Control Change status E.PIANO 1 LED status
Enabled Lit
Disabled Dark
PC# Button Bank Sound
MEMMEM
MEMMEM