50 Chapter 8
Check after assembly
[•] Are any parts left over?
If any parts are left over, check the diagrams to see where they should be used.
[•] Make sure that all screws and bolts are tight.
Caution
Caution when transporting the instrument. Remove the piano from its stand, and
transport them separately. After transportation, refer to these instructions and re-
assemble the piano and stand.
Screw loosening. After assembly, the various screws and bolts of the stand may
loosen as time goes by, causing the stand to wobble. If this occurs, re-tighten the
screws and bolts.
Disassembly. If you need to packup the EC350, reverse the assembly order by
which the piano was attached to the stand and the stand was assembled. After disas-
sembly, save the screws and other parts so that no parts are lost.
To Next Page
Loading...
