Assembling the stand 49
11 Connect the pedal and power cables to the corresponding piano connectors. Fix the
power supply cable with the dedicated cable-holder, as shown in the diagram.
12 Place the piano in the location where it will be played.
Note: Be careful not to pinch the power cable under the piano feet.
13 Regulate the screwable pedal-adjuster (d) underneath the pedals, so that it touches
the ground.
14 Tighten and check all the screws and bolts.
15 When finished assembling the piano, you must remove the key cover security string.
Use a cross-point screwdriver to completely remove the screw underneath the piano.
Do not insert the screw again.
d
To Next Page
Loading...
