Assembling the stand 47
7 If you like, turn the stand over, with the outer part of the right leg panel resting on
the floor, and, after removing the protective tape, fix the power supply (F) with the
Velcro strip located under the pedal beam, as shown in the diagram. Fix power sup-
ply cables with the small clamps located under the pedal beam, as shown in the dia-
gram.
8 With two persons, lift the piano (E) in such a way as to be able to get to its bottom
part. Screw the short bolts (c) a few millimeters into the two holes near the back of
the piano. Leave most of the bolts free (not fully tightened).
F
FF
c
c
E
To Next Page
Loading...
