Korg HT-10 - Troubleshooting

9
Troubleshooting
Power won't turn on
● IstheDCplugoftheACadapterconnectedtotheHT-10'sDC12Vconnector?
● IsthepowercableoftheACadapterconnectedtoanACoutletofthecorrectvolt-
age?
● Isthepowerturnedon?
● Ifthepowerstilldoesnotturnon,disconnecttheACadapterpowercablefrom
the AC outlet, and contact a service center.
No sound
● CouldtheHT-10'sVOLUME knob beturnedallthewaytotheleft(before the
“STANDBY”position)?
Sound is interrupted
● The preset sounds oftheHT-10havebeencreatedbysampling(recording)the
sounds of actual instruments, then analyzing and processing the samples. When
you press a key, some sounds play a single piece of sampled data, while other
sounds play two pieces of sampled data. The HT-10 uses two pieces of data for
most of its preset sounds. When one of these two-sample sounds is selected (re-
gardlessofwhetherthedamperpedalisbeingpressed),themaximumpolyphony
is60notes.However,withtwoPianosounds,themaximumpolyphonyis120
notes.Ifthemaximumpolyphonyisexceeded,someofthenoteswillbelost.
The pitch or tone of the piano sounds wrong in some key regions
● The HT-10’s piano sounds replicate the sound of an actual piano as faithfully as
possible. This means that in some regions of the keyboard, you may feel that the
overtones seem stronger, or that the tone or pitch seems wrong. This is not a mal-
function
.
A specic key does not sound, or is too loud or soft
● Thekeymaynotbeaccuratelycalibrated.Pleasecontactacertiedservicetechni-
cian or your local Korg dealer.
● Themuteunitmaycausetheproblemlistedaboveifitisnotregularlymaintained
andadjustedbyacertiedservicetechnician.Werecommendthatyouhaveyour
piano tuned and adjusted once a year.