Korg HT-10 - Connecting the Power; Adjusting the Volume

3
Internal Setup and Connections
Connecting the Power
(Figure 1)
Start with the HT-10 turned OFF. Connect the
supplied AC adapter to the power cord. Insert
the DC plug end into the DC12V jack on the rear
panel.Next,plugthepowercord intoanAC
outlet.
Be sure to use the supplied AC adapter. Us-
ing other AC adapters may cause the unit to
malfunction.
Be sure to plug the unit into an AC outlet of
an appropriate voltage.
Turning the HT-10 ON
RotatetheVOLUMEknobtowardtheright to
turn on the power. (Figure 2)
ThepowerLEDwilllightup.
Toturn the powero,turn the VOLUMEknob
towardtheleuntilitreachesthe“STANDBY”
position.ThepowerLEDwillgodark.
There will be a “click” when you turn the power
onoro.
Adjusting the volume
RotatetheVOLUMEknobtoadjustthevolume.
(Figure 2)
TheVOLUMEknobcontrolstheoutputlevelof
the headphone jacks.
Figure 1
AC adapter
Operation panel
Bottom panel
of piano
DC plug
Power cable
for AC adapte
r
to an AC outlet
Figure 2
On
Softer
Louder
Power LED
Headphone Jacks