Korg HT-70 - Page 13

13
Changing the Loudness
1. Hold down [ ] for at least one second.
The switch begins flashing.
2. Press the [VOL. (PART 2)] switch.
The switch lights up, and the multidisplay shows the current volume setting.
3. Use [▲] or [▼] to set the desired level.
Press briefly to change the value by 1, or hold the switch down to change continuously.
The available range is 0 to 127.
4. When you have set the value, press [ ] again.
The HT-70 returns to its previous state. The [ ] switch stops flashing (either goes off
or else comes on solid).
Changing the time signature
1. Hold down [ ] for at least one second.
The switch begins flashing.
2. Press the [BEAT (PART 1)] switch.
The switch lights up, and the multidisplay shows the current time signature.
3. Use [▲] or [▼] to set the desired time signature.
4. When you have set the value, press [ ] again.
The HT-70 returns to its previous state. The [ ] switch stops flashing (either goes off
or else comes on solid).
Changing the Accent
1. Hold down [ ] for at least one second.
The switch begins flashing.
2. Press the [BELL(●)] switch.
The switch lights up, and the multidisplay shows the current accent sound.
Display 1-2 2-2 1-4 2-4 3-4 4-4 6-8
Time signature 1/2 2/2 1/4 2/4 3/4 4/4 6/8
1, 4
2
3
3
1, 4
2
3
3
1, 4
2
3
3