Korg iM1 - Timbre Parameters

Available Parameters by Mode
19
Timbre Parameters
Here you can select the program used by each timbre, and set
the output level, pan, and output destination of each timbre.
Timbre Select.................................................................................. [1…8]
This selects the current timbre that is available for editing. To
select a timbre, click the timbre number or the bar shown at
either edge of the parameter area.
When you tap the on-screen keyboard or drag the pitch bend
or modulation wheel to operate them, MIDI messages will be
transmitted on the MIDI channel of the timbre you’ve
selected here. If you’re controlling the iM1 for iPad from an
external MIDI device, you won’t hear anything unless the
MIDI channel of your external MIDI device matches the MIDI
channel of the timbre you’ve selected here. The same applies
to the pitch bend wheel and modulation wheel.
The editing area at the right will show the parameters
(selected by the [Timbre Select] switches) of the program
used by this timbre, allowing you to edit them.
TIMBRE ON/OFF ............................................................................ [ON, OFF]
These buttons specify whether each track will produce
sound.
SOLO.............................................................................................[OFF, ON]
Only the Timbre(s) that is soloed will sound. By soloing a
Timbre, you can isolate it for easy editing.
MUTE............................................................................................[OFF, ON]
The mute function is almost an opposite of the Solo function.
Use the mute feature to temporarily silence a particular Tim-
bre(s), without removing it from the Combi.
IFX ...............................................................................................[OFF, ON]
This function turns the Insert effect on or off for the selected
Timbre.
"OFF (dark): The Insert effect section is bypassed.
"ON (lit): The Insert effect section is active.
The IFX is automatically turned on when you select a
Program.
Timbre Select
Timbre ON/OFF