Korg iM1 - Program Mode

Introduction
6
Program mode
This mode is used to play and edit individual Programs.
Programs can be selected from the 32 preset cards and from
the new KLC PRESET card and iM1 Special card. Programs
that you have tweaked, edited, or created from scratch can be
saved to any of the six User cards. Each User card can hold 50
Programs, for a total of 300 user Programs.
Each Program uses one of the three oscillator modes: Single,
Double, or Drums.
Single
Single Programs use a single oscillator. The oscillator consists
of the OSC, VDF, VDA, and Insert FX sections.
The multisounds available for use by the oscillator can be
selected from the 16 preset cards.
Double
Double Programs use two oscillators. Each oscillator consists
of the OSC, VDF, and VDA sections. The combined output of
the oscillators is routed to the Insert FX.
Drums
Drum Programs use a Drum Kit as the oscillator. The Drum
Kit oscillator consists of an OSC, VDF, VDA, and the Insert
FX.
On the original M1, the SETTINGS mode was used to edit a
Drum Kit. The iM1 for iPad now allows the Drum Kit param-
eters to be part of the Program.
Insert FX 1
Insert FX 2
Insert FX
OSC 1
Multisound
VDF
VDA
Insert FX 1
Insert FX 2
Insert FX
OSC 1
Multisound
VDF
VDA
OSC 2
Multisound
VDF
VDA
Insert FX 1
Insert FX 2
Insert FX
OSC 1
Drumkit
VDF
VDA