Available Parameters by Mode
54
TIMBRES Parameter
Here you can edit the program’s output level, pan, and out-
put destination.
TIMBRE ON/OFF ............................................................................[ON, OFF]
These buttons specify whether each timber will produce
sound.
IFX............................................................................................... [OFF, ON]
This function turns the Insert effect section On and Off.
OFF (dark): The Insert effect section is bypassed.
ON (lit): The Insert effect section is active.
The IFX is automatically turned on when you select a
Program.
PROGRAM Select ....................................................................... [BROWSER]
Using the Browser, select the Program to be used by the Tim-
bre.(Refer to "The Browser" on page 14)
LEVEL ..........................................................................................[00…99]
This knob specifies the output level of the Program
PAN................................................................................[L50…C00…R50]
This knob specifies the position in the stereo field (pan) of the
Program
If DRUMS is specified as the oscillator mode ("OSC
MODE" on page 29) in this Program the "PAN" field
will not appear. Use the "PAN" setting in the DRUM
KIT EDIT section ("PAN" on page 20) of the OSC page
to specify the pan of each sound in the Drum Kit.
OSC, VDF, VDF&VDA, EG, INSERT FX
These parameters are the same as in Combination mode.
Refer to "PERFORMANCE page" on page 21.
To Next Page
Loading...
