Korg iM1 - Multi Mode

Introduction
5
Multi mode
In this mode, the iM1 for iPad can be used as an eight-part
multi-timbral sound module..
Multi mode and Combination mode are structured almost
identically, but have the following differences.
• Default MIDI channel setting for each track (track 1 is chan-
nel 1, track 2 is channel 2, …)
• In Multi mode, the master effects are used as send effects.
The send levels, return levels, and return destinations will
determine how the signal is routed. If you lower the send
levels to 0, the signals from the insert effects will be output
directly, bypassing the master effects. If you raise the send
levels, the direct sound will be mixed with the signals from
the master effects and then output.
Except for the points listed above, Combination mode and
Multi mode have the same structure. You can use Combina-
tion mode as a multi-timbral sound module, or use Multi
mode to create a single sound just like a combination.
Program
MFX 1
MFX 2
Track 1
Track 8
Track 2
Track 3
Track 4
Track 5
Track 6
Track 7
Program
Program
Program
Program
Program
Program
Program
Master FX
Return