Korg iM1 - Page 29

Available Parameters by Mode
29
OSC
OSC MODE .............................................................[SINGLE, DOUBLE, DRUM]
This parameter selects the oscillator mode.
MULTISOUND 1/MULTISOUND 2/DRUMKIT.....................................[BROWSER]
Tap here to open the Browser to select a multisound or Drum
Kit. Refer to "The Browser" on page 14
LEVEL...........................................................................................[00…99]
This parameter specifies the oscillator's output level.
VDF
VDF SELECT
Use this function to determine whether VDF1 or VDF2 will be
shown in the active editing display.
CUTOFF ........................................................................................[00…99]
This parameter specifies the cutoff frequency. Drag the point
in the graphic.
RESONANCE..................................................................................[00…99]
This parameter specifies the resonance. Drag the point in the
graphic.
RESONANCE Switch ....................................................................... [OFF, ON]
This parameter turns the filter resonance on or off.
Refer to "RESONANCE Switch" on page 37
EG INT 1 ......................................................................................[00…99]
This parameter specifies how deeply the VDF EG1 will be
applied.
EG INT 2 .......................................................................................[00…99]
This parameter specifies how deeply the VDF EG2 will be
applied.