Available Parameters by Mode
37
VDF1
CUTOFF ........................................................................................[00…99]
Use this parameter to set the VDF filter cutoff frequency.
RESONANCE Switch ....................................................................... [OFF, ON]
The iM1 for iPad adds a new RESONANCE parameter that
was not included on the original M1. The CUTOFF response
will vary depending on whether this is ON or OFF. In order
to faithfully reproduce the preset sounds of the original M1,
the RESONANCE Switch is normally turned OFF. If you
want to use resonance, turn the RESONANCE Switch ON.
RESONANCE..................................................................................[00…99]
This parameter boosts the filter response at the cutoff fre-
quency.
EG INT..........................................................................................[00…99]
This parameter specifies the depth of tonal change produced
by the VDF 1 EG.
Refer to M1 owner’s manual PDF, page 25 “F2-1: VDF1”
VDF 1 EG
The shape of the VDF1 EG can be easily modified by simply
dragging the points of the graphical envelope in the display.
(Refer to "Graphical envelopes" on page 11)
Refer to M1 owner’s manual PDF, page 25 “F2-2: VDF1 EG”
VEL SENS
This important set of Velocity Sensitivity parameters can help
determine how the dynamics of a performance will affect the
articulation of the sound. Performance dynamics-Velocity
Level-can be used to increase or decrease the timing of each
stage of the EG, as well as the overall intensity of the EG.
Refer to M1 owner’s manual PDF, page 26 “F2-3: VDF1 VEL
SENS”
EG INT...........................................................................[–99…+00…+99]
This parameter will control how velocity sensitivity can
increase or decrease the EG intensity.
EG TIME .......................................................................................[00…99]
This parameter will control how velocity sensitivity will alter
the timing of each envelope stage.
Refer to "OSC1" on page 32
TIME POLARITY A, D, S, R .................................................................[+, x, –]
The value set by the previous EG TIME parameter can be
applied to lengthen (+) or shorten (-) each envelope stage
individually; A (Attack Time), D (Decay Time), S (Slope
Time), and R (Release Time). Using a value of (X) means no
change is applied.
KBD TRK
Keyboard tracking allows the note number of the key being
played to affect certain parameters.
To Next Page
Loading...
