Korg iM1 - Page 24

Available Parameters by Mode
24
MIDI Ch
MIDI Ch........................................................................................[01…16]
This parameter specifies the MIDI channel for each Timbre.
KEY ZONE
By setting a Top key and a Bottom key, Zoning allows you to
limit and/or specify the range of keys played by each Timbre.
TOP............................................................................................[C–1…G9]
BOTTOM.....................................................................................[C–1…G9]
VELOCITY ZONE
By setting a Top velocity level and a Bottom velocity level,
this type of Zoning allows you to limit and/or specify the
range of MIDI velocity levels played by each Timbre.
TOP.......................................................................................... [001…127]
BOTTOM................................................................................... [001…127]
MIDI FILTER
MIDI Filtering can selectively determine which MIDI mes-
sages are received by each Timbre.
Activate the MIDI filter by turning it on (lit) to prevent the
specific type of message from being received.
PC (Program Change).................................................................... [OFF, ON]
OFF (dark): Program Change messages are received.
ON (lit): Program Change messages are not received (fil-
tered).
CC (Control Change) .......................................................................[OFF, ON]
OFF (dark): Control Change messages are received.
ON (lit): Control Change messages are not received (filtered).
AT (After Touch).............................................................................[OFF, ON]
OFF (dark): Aftertouch messages are received.
ON (lit): Aftertouch messages are not received (filtered).
DMP (Damper) ..............................................................................[OFF, ON]
OFF (dark): Damper pedal messages are received.
ON (lit): Damper pedal messages are not received (filtered).
DETUNE
DETUNE ........................................................................[–50…+00…+50]
This parameter adjusts the pitch of each Timbre in one-cent
steps.
TRANSPOSE
TRANSPOSE ...................................................................[–12…+00…+12]
This parameter adjusts of each Timbre in semitone steps.