Korg iM1 - Page 43

Available Parameters by Mode
43
CONTROLLER
In addition to MIDI keyboards, there are many MIDI control-
lers and control surfaces that can send a MIDI CC signal to
expressively alter certain sound-creation parameters in the
iM1.
Refer to M1 owner’s manual PDF, page 33 “F7-2: JOY STICK”
PITCHBEND................................................................... [–12…+00…+12]
This parameter specifies the pitch bend range of an external
controller.
This setting may have no effect, depending on the SET-
TINGS mode "GLOBAL PITCHBEND Switch" setting.
(Refer to "GLOBAL PITCHBEND" on page 57)
VDF SWEEP INT ............................................................. [–99…+00…+99]
This parameter specifies the amount of VDF cutoff frequency
change produced by an external controller.
PITCH MG INT................................................................................[00…99]
This parameter specifies the degree to which an external con-
troller will affect the PITCH MG depth.
PITCH MG FREQ/PITCH MG TIMES ....................................................... [0…3]
This parameter specifies how an external controller will affect
the PITCH MG speed as a ratio relative to the "FREQ/TIMES"
value of the OSC page.
This setting will be either PITCH MG FREQ or PITCH MG
TIMES, depending on the OSC page "TEMPO SYNC" setting.
VDF MG INT ..................................................................................[00…99]
This parameter specifies the degree to which an external con-
troller will affect the VDF MG depth.
VDF MG FREQ/VDF MG TIMES..............................................................[0…3]
This parameter specifies how an external controller will affect
the VDF MG speed as a ratio relative to the "FREQ/TIMES"
value of the VDF page.
This setting will be either VDF MG FREQ or VDF MG TIMES,
depending on the VDF page "TEMPO SYNC" setting.
VDA MG INT..................................................................................[00…99]
This parameter specifies the degree to which an external con-
troller will affect the VDA MG depth.
VDA MG FREQ/VDA MG TMES ..............................................................[0…3]
This parameter specifies the how an external controller will
affect the VDA MG speed as a ratio relative to the "FREQ/
TIMES" value of the VDA page.
This setting will be either VDA MG FREQ or VDA MG
TIMES, depending on the VDA page "TEMPO SYNC" setting.