EasyManuals Logo
Home>Korg>Synthesizer>MicroKORG XL

Korg MicroKORG XL User Manual

Korg MicroKORG XL
103 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #75 background imageLoading...
Page #75 background image
Effect guide
75
DELAY ...................................................................... [00.0…30.0ms]
Sets the delay time in millisecond steps.
MOD.DEPTH (Modulation Depth) .......................................[000…127]
Sets the depth of LFO modulation.
FEEDBACK .......................................................................[000…127]
Sets the amount of feedback for the left and right channels.
PHASE ..........................................................................................[+, –]
This switches the phase of the output and feedback.
LFO SYNC (LFO Tempo Sync) .......................................................[OFF, ON]
Specifies whether the LFO cycle will be synchronized with the tempo speci-
fied by the [TEMPO] knob or MIDI clock.
J p. 66 “LFO SYNC (LFO Tempo Sync)”
LFO FREQ (LFO Frequency) ........................................ [0.01…100.0Hz]
Sets the LFO speed.
J p. 66 “LFO FREQ (LFO Frequency)”
SYNC.NOTE (LFO Sync Note) .............................................. [8/1…1/64]
Sets the LFO frequency as a proportion of the tempo set by the [TEMPO]
knob. J p. 66 “SYNC.NOTE (LFO Sync Note)”
NOTE
This parameter will be displayed and can be set if “LFO SYNC” is ON.
LFO WAVE (LFO Waveform) ............... [SAW, SQUARE, TRIANGLE, SINE, S&H]
Selects LFO Waveform. J p. 66 “LFO WAVE (LFO Waveform)”
LFO.SHAPE ..........................................................................[–63…+63]
J p. 66 “LFO.SHAPE”
KEY SYNC (LFO KeySync) ............................................................[OFF, ON]
Specifies whether the LFO will be reset by note-on.
J p. 67 “KEY SYNC (LFO KeySync)”
INI.PHASE (LFO Init Phase) ...................................................[000…180°]
Sets the starting location of the waveform. J p. 67 “INI.PHASE (LFO Init
Phase)”
NOTE
This parameter will be displayed and can be set if “KEY SYNC” is ON.
LFO SPRD (LFO Spread)....................................................[–180…+180°]
Sets the LFO phase difference between the left and right channels.
HI DAMP (High Damp) ........................................................[000…100%]
Sets the feedback damping amount in the high range.
13. VIBRATO (Stereo Vibrato)
Vibrato
Vibrato
Left
Right
Dry / Wet
Dry / Wet
Stereo In - Stereo Out
LFO
LFO Shape
LFO Spread
This effect causes the pitch of the input signal to shimmer. Using the Auto-
Fade allows you to increase or decrease the shimmering speed.
DRY/WET...................................................... ["DRY", 99:1…1:99, "WET"]
Sets the balance between the effect and dry sounds.
MOD.DEPTH (Modulation Depth) ...................................... [000…127]
Sets the depth of LFO modulation.
LFO SYNC (LFO Tempo Sync) .......................................................[OFF, ON]
Specifies whether the LFO cycle will be synchronized with the tempo speci-
fied by the [TEMPO] knob or MIDI clock.
J p. 66 “LFO SYNC (LFO Tempo Sync)”
LFO FREQ (LFO Frequency) .........................................[0.01…100.0Hz]
Sets the LFO speed.
J p. 66 “LFO FREQ (LFO Frequency)”
Effect Guide

Table of Contents

Other manuals for Korg MicroKORG XL

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Korg MicroKORG XL and is the answer not in the manual?

Korg MicroKORG XL Specifications

General IconGeneral
BrandKorg
ModelMicroKORG XL
CategorySynthesizer
LanguageEnglish

Related product manuals