17
SYNC switch [OFF/ON]
This switch lets you sync the oscillators.
Oscillator sync is a popular effect for creating edgy synth leads.
ON (up position): With this type of modulation, the phase of oscillator 2 is forcibly synchronized
to the phase of oscillator 1. This adds harmonic overtones to the frequency of oscillator 2, making
a complex waveform.
RING switch [OFF/ON]
This lets you achieve a ring modulation effect.
Adjust the pitch of oscillator 2 to create non-tonal and metallic sounds.
ON (up position): Oscillator 1 is used to ring modulate oscillator 2.
CROSS MOD DEPTH knob [0...1023]
Cross Mod (Modulation) allows oscillator 1 to modulate the pitch of oscillator 2.
Turning the knob to the right results in stronger modulation.
MULTI ENGINE
The MULTI ENGINE is a digital sound generation en-
gine.
This engine operates as a noise generator, a VPM os-
cillator or a user oscillator, to make a wide range of
sounds not possible with analog oscillators. You can
load your own oscillator programs into the user oscilla-
tor to make sounds.
NOISE/VPM/USR switch [NOISE , VPM , USR]
This sets which engine will be used, the noise generator, VPM oscillator or user oscillator.
NOISE: The MULTI ENGINE is used as a noise generator.
VPM: The MULTI ENGINE is used as a VPM oscillator.
USR: The MULTI ENGINE is used as a user oscillator.
The TYPE knob and SHAPE knob work differently, depending on the NOISE/VPM/USER switch
setting. The settings are explained below.
Sync
VCO 1 Wave
VCO 2 Wave (original)
VCO 2 Wave (output)
VCO 2
VCO 1
RING MOD
To Next Page
Loading...
