9
Playing the minilogue xd
Selecting and playing a program
The minilogue xd features 500 program memories. When the unit is shipped from the factory,
preset programs are assigned to program numbers 1–200. Programs 201–500 contain init programs
(programs that have been initialized).
1.
Check that the minilogue xd is in Play mode.
In Play mode, verify that the EDIT MODE button on the front panel is unlit. If the EDIT MODE
button is lit, press the EXIT button.
2.
Turn the PROGRAM/VALUE knob to select a program.
The display will indicate the program name. For details, refer to “Program list” (p.55).
Tip: In addition to showing the program name, the display can also be used as an oscilloscope
to show the waveform created by the electrical signals of the sound.
3.
Play the keyboard and try using the joystick and OCTAVE switch and other controls on the
front panel.
You can use the OCTAVE switch to transpose the playing area of the key-
board by ±2 octaves.
The joystick mainly controls the pitch when moved from left to right, and
changes parameters such as the cutoff frequency and vibrato depth when
moved up and down. You can also change which parameters are controlled
by the joystick. See “Button 4 (JOYSTICK)” (p.32) for details.
Use the VOICE MODE TYPE switch to switch between voice
modes. Select a voice mode and play. To learn more about voice
modes, see “VOICE MODE section” (p.15).
2
Make sure this button is unlit.
1
To Next Page
Loading...
