Korg Minilogue XD - Page 8

8
Turning the minilogue xd off
Any program data in the minilogue xd that has not been saved will be lost when the power is
turned off. Be sure to save any programs and other important data that you have edited (p.14
“Saving a program”).
1.
Lower the volume of your powered monitors or external output system, and turn them o.
2.
Hold down the Power switch on the rear panel of the minilogue xd; to turn o the power
after the display goes blank, take your nger o the power switch.
After turning the minilogue xd off, wait about 10 seconds before turning it on again.
Auto power off feature
The minilogue xd features an auto power off feature that can automatically turn the minilogue xd
off after 4 hours have elapsed with no operation of the knobs, switches, buttons, or keyboard. By
default, the factory setting for auto power off is enabled. The auto power off can be disabled us-
ing the steps below.
1.
Press the EDIT MODE buon.
The minilogue xd will enter Edit mode, and the display will look like the illustration shown
below.
2.
Turn the PROGRAM/VALUE knob, and select “GLOBAL EDIT.”
The minilogue xd will enter GLOBAL Edit mode.
Tip: GLOBAL EDIT can also be selected by pressing the EDIT MODE button.
3.
Press buon 8 three times.
“Auto Power Off” will be displayed.
4.
Turn the PROGRAM/VALUE knob, and select “O”.
5.
Press the EXIT buon.
The minilogue xd will enter Play mode, and the display will indicate the current program.
123456781110 12913141516
3
1
2, 4
5