Korg Minilogue XD - EG and LFO Section

22
EG/LFO section
AMP EG VCA: Voltage Controlled Amplifier / EG: Envelope Generator
These are the settings for the envelope generator (EG), which
controls changes in the signal volume of the VCA over time.
ATTACK knob [0...1023]
The ATTACK specifies the time required for the EG to reach its maximum level once a new note is
played (note-on).
DECAY knob [0...1023]
The DECAY specifies the time required for the EG to fall to the preset sustain level once the attack
portion of the EG is complete.
SUSTAIN knob [0...1023]
The SUSTAIN specifies the level that will be maintained after the decay time while the key is held
down.
RELEASE knob [0...1023]
The RELEASE specifies the time required for the EG to reach its minimum level (zero) once the
key or trigger is released (note off).
EG EG: Envelope Generator
The envelope generator (EG) is used to change the pitch and cutoff frequency over time.
ATTACK knob [0...1023]
The ATTACK specifies the time required for the EG to reach its maximum level once a new note is
played.
DECAY knob [0...1023]
The DECAY specifies the time required for the EG to fall to the preset sustain level once the attack
portion of the EG is complete.
EG INT knob [–100%... 0%...+100%]
Adjusts the intensity of the EG.
Turning the knob to the right will increase the intensity.
When set to a negative value, the EG will be applied in the negative direction.
TARGET switch [PITCH, PITCH 2, CUTOFF]
This sets what the EG will be applied to.
PITCH: Applies the EG to the pitch of VCO 1, VCO 2 and the MULTI ENGINE.
PITCH 2: Applies the EG to the pitch of VCO 2.
CUTOFF: Applies the EG to the cutoff frequency of the FILTER.
0
Attack Level
Time
Note on Note o
Level
Sustain
Level
Attack
Time
Decay
Time
Release
Time