16
Type Action VOICE MODE DEPTH knob eect
ARP/LATCH Uses the arpeggiator to play up
to 4 voices.
Switches between LATCH ON
and OFF.
Set the arpeggiator tempo, swing
and gate time using the “TEMPO
knob” (p.15), “Swing” (p.37)
and “Default Gate Time”
(p.37) settings.
[MANUAL 1, MANUAL 2, RISE 1, RISE 2, FALL 1,
FALL 2, RISE FALL 1, RISE FALL 2, POLY 1, POLY 2,
RANDOM 1, RANDOM 2, RANDOM 3]
Selects the arpeggiator type.
If you set the VOICE MODE TYPE switch
to ARP/LATCH and then move the switch
down, the latch will be turned on (the LED
will blink), and the arpeggiator will keep
playing even after you take your hands off
the keyboard. If you move the switch up
while latched, the switch will latch off (the
LED will light).
VCO 1/VCO 2/MULTI ENGINE section
VCO 1, VCO 2
VCO: Voltage Controlled Oscillator
There are two oscillators in the minilogue xd. Here, we will
adjust the basic settings for the sound, including pitch (OC-
TAVE, PITCH), waveform (WAVE, SHAPE) and so on.
WAVE switch [SQR , TRI , SAW ]
This sets the waveforms for oscillators 1 and 2.
SQR (square wave): This waveform is used for electronic
and wind instrument sounds.
TRI (triangle wave): This waveform has a rounder feel than
the sawtooth or square wave.
SAW (sawtooth wave): This waveform is used to create sounds typical of analog synthesizers,
such as synth basses and synth brass.
OCTAVE switch [16’, 8’, 4’, 2’]
The pitch of oscillators 1 and 2 can be set in octave steps.
PITCH knob [–1200...+1200]
The pitch, or tuning, of oscillators 1 and 2 can be set in one-cent steps.
SHAPE knob [0...1023]
This knob will determine the final shape, complexity, or duty-cycle (square) of the selected wave-
form for oscillators 1 and 2.
To Next Page
Loading...
