35
Button 8 (MODULATION)
EG Velocity [0..127]
Sets the strength of the Cutoff EG Int using velocity. EG Velocity is used to specify how much the
EG Int will change according to the keyboard velocity.
If EG Int is set to any other value besides “0”, the keyboard velocity can be used to soften the EG
Int.
Amp Velocity [0..127]
Amp Velocity is used to specify how much the volume will change according to the keyboard
velocity.
0: The velocity will have no effect.
The larger the value, the more effect that keyboard velocity will have.
Button 9 (OTHER SETTINGS)
Multi Octave [16΄, 8΄, 4΄, 2΄]
You can set the transposition of the MULTI ENGINE in octaves.
Multi Routing [Pre VCF, Post VCF]
This sets whether the MULTI ENGINE is mixed prior to the signal reaching the VCF, or whether
to bypass the VCF and mix.
Note: When this is set to “Post VCF,” the VCF will not affect the MULTI ENGINE.
EG Legato [Off, On]
When the voice mode is set to “UNISON” or “CHORD,” this sets what happens with the EG when
a key is played in legato while another key is being pressed.
Off: The EG will be retriggered.
On: The EG will not be retriggered.
Portamento Mode [Auto, On]
Auto: When playing in a legato style (playing a new note before any previously played note is
released), portamento will be applied.
On: Portamento will be applied, even when fully releasing a key and then playing the next note.
Portamento BPM [Off, On]
On: The length of portamento that is set using the PORTAMENTO knob will be synchronized
with the BPM (beats per minute).
Program Level [–18.0dB...0.0 dB...+6.0dB]
Sets the program volume.
This allows you to adjust the volume of a program relative to other programs.
Increasing this value will make the volume louder.
To Next Page
Loading...
