455
Assembling the ST-SV1 BK stand
Appendix
6. Turn the stand (B) upside down, so that the feet are laying
on the floor. Place the concave side of the bracket (f)
toward you.
7. Adjust the height of the feet (g), by turning them by hand
and leveling the stand on each side, even if it is not com-
pletely even. We suggest you prevent the nut (h) from turn-
ing with the help of the supplied 11/16” wrench (i). After
adjusting each of the feet, make sure that the nut (h)
touches the leg’s border.
8. Using two people, lift the piano (A), and attach it to the
stand (B). While one person prevents the instrument from
falling down, the other should make the small rubber foot
(k) under the instrument line-up to the concave side of the
bracket (f), and the screw (l) under the instrument with the
space left on the side of the convex side of the bracket (m).
Align the holes (n) under the piano to match the screws (o)
of the stand.
Wa rn ing : During this step, do not apply weight to the
instrument, otherwise it may fall down.
9. If the instrument and the stand are correctly aligned, the
screws (o) should fit into the threaded nuts of the holes (n).
If this does not happen, align the instrument and stand
again. Once the screws are inside the threaded nuts, tighten
them to attach the instrument to the stand.
10. Be sure all screw are tightened, and all brackets correctly
inserted.
11. Place the instrument in the location where it will be played.
Pa3XLe User Manual v100 (English).book Page 455 Thursday, May 29, 2014 5:42 PM
To Next Page
Loading...
