1–3: OSC 1 Pitch
Here, you can make settings for the basic pitch of oscillator 1, pitch modulation, and pitch slope.
1–3a: Basic Pitch
Specifies the basic pitch of oscillator 1
Octave [32'…4']
Specifies the basic pitch of oscillator 1 in steps of an octave. 32' is two octaves below, 16' is one octave below, 8'
is standard pitch, and 4' is one octave above.
Transpose [–12…+12]
Adjusts the basic pitch specified by “Octave” in semitone steps.
Tune [–50…+50]
Makes fine adjustments to the pitch in one-cent steps.
Frequency Ofs [–10.0…+10.0]
Makes fine adjustments to the pitch in 0.1 Hz steps.
1–3b: Pitch Modulation
Specifies the pitch Modulation.
AMS.1 (Alternate Modulation Source 1) [OFF…MIDI (CC#83)]
Selects a modulation source 1 (
☞
page 64 of this manual) which will modify the pitch (e.g., apply vibrato).
Intensity (Pitch AMS.1 Intensity) [–99…+99]
Specifies the depth and direction of the pitch change that will be controlled by “AMS.1.”
AMS.1 Int (AMS.1 Intensity Alternate Modulation Source) [OFF…MIDI (CC#83)]
Specifies the controller (
☞
page 64 of this manual) that will control the “Intensity (Pitch AMS.1 Intensity).”
Intensity (AMS.1 Int AMS Intensity) [–99…+99]
Specifies the depth of the pitch modulation effect controlled by “AMS.1 Int .”
1–3a
1–3b
1–3c
1-3: OSC 1 Pitch
To Next Page
Loading...
