Korg Synthesizer User Manual

2:1 OSC 1 (03: VPM)
Parameters
Prog.
Edit
P2
03: VPM
The output of a carrier is phase-modulated by a modulator, and output through wave shape processing.
By controlling the wave shaping parameters and the feedback gain, tonal changes that are different
than simple phase modulation can be produced.
2–1a: Carrier
Wave [Saw, Square, Triangle, Sine]
Selects the carrier waveform.
Level [0…99]
Specifies the output level of the carrier. This will determine the output level of the VPM oscillator.
AMS.1 (Alternate Modulation 1 Source) [OFF…MIDI (CC#83)]
Selects a modulation source 1 (
☞
page 64 of this manual) that will control “Level.”
Intensity (Level AMS.1Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.1.”
AMS.2 (Alternate Modulation 2 Source) [OFF…MIDI (CC#83)]
Selects a modulation source 2 (
☞
page 64 of this manual) that will control “Level.”
Intensity (Level AMS.2 Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.2.”
2–1b: Wave Shape
Shape [0…99]
Specifies the number of cycle of wave shaping. As this value is increased, the number of cycles will increase,
causing more overtones to be added to the high-frequency range of the sound.
2-1a
2–1b
2–1c
2–1d
2–1e
Modulator Pitch
Carrier Pitch
(Basic Pitch)
Carrier Level
Output
Wave Shape Parameter
Feedback Gain
Modulator Level
Modulator
Carrier
Wave
Shape
Table valiation
Shape:0 Shape:99
Table Variation

Korg Synthesizer Specifications

General

Brand	Korg
Model	Synthesizer
Category	Music Equipment
Language	English