3–1b: OSC 1 ➝ Out 2
These parameters adjust the level at which the oscillator 1 signal is output from mixer output 2, and
specify a modulation source that will control this level.
Refer to the above explanation of “3-1a: OSC1 ➝ OUT1.”
3–1c: OSC 2 ➝ Out 1
These parameters adjust the level at which the oscillator 2 signal is output from mixer output 1, and
specify a modulation source that will control this level.
Refer to the above explanation of “3-1a: OSC1 ➝ OUT1.”
3–1d: OSC 2 ➝ Out 2
These parameters adjust the level at which the oscillator 2 signal is output from mixer output 2, and
specify a modulation source that will control this level.
Refer to the above explanation of ”3-1a: OSC1 ➝ OUT1.”
3–1e: Sub ➝ Out 1
These parameters adjust the level at which the sub oscillator signal output is output from mixer
output 1, and specify a modulation source that will control this level.
Refer to the above explanation of “3-1a: OSC1 ➝ OUT1.”
3–1f: Sub ➝ Out 2
These parameters adjust the level at which the sub oscillator signal output is output from mixer
output 2, and specify a modulation source that will control this level.
Refer to the above explanation of “3-1a: OSC1 ➝ OUT1.”
3–1g: Noise ➝ Out 1
These parameters adjust the level at which the output of the noise generator is output from mixer
output 1, and specify a modulation source that will control this level.
Refer to the above explanation of “3-1a: OSC1 ➝ OUT1.”
3–1h: Noise ➝ Out 2
These parameters adjust the level at which the output of the noise generator is output from mixer
output 2, and specify a modulation source that will control this level.
Refer to the above explanation of “3-1a: OSC1 ➝ OUT1.”
3–1i: Feedback ➝ Out 1
These parameters adjust the level at which the feedback from the amp section is output from mixer
output 1, and specify a modulation source that will control this level.
Refer to the above explanation of “3-1a: OSC1 ➝ OUT1.”
Raising the Feedback level excessively may cause the sound to distort.
3–1j: Feedback ➝ Out 2
These parameters adjust the level at which the feedback from the amp section is output from mixer
output 2, and specify a modulation source that will control this level.
Refer to the above explanation of “3-1a: OSC1 ➝ OUT1.”
Raising the Feedback level excessively may cause the sound to distort.
3-1: Mixer
To Next Page
