Low Int. [–99…+99]
Specifies the depth and direction of cutoff frequency change that will occur below the “Low Key.” With a
setting of –50, the change will match the change in pitch.
High Int. [–99…+99]
Specifies the depth and direction of cutoff frequency change that will occur above the “High Key.” With a
setting of +50, the change will match the change in pitch.
3–3d: Resonance B
Resonance [0…99]
This setting emphasizes the overtones in the region of the “Frequency” to add character to the sound. Higher
values will produce a stronger effect. With high settings of resonance, the output signal of the filter may distort.
If this occurs, reduce the “Input Trim” setting.
With the Dual BPF filter type, the overtones in the vicinity of each cutoff frequency will be affected in the same
way as by a BPF.
AMS Intensity [–99…+99]
Specifies the depth and direction of the effect that the AMS specified in “3-2e: Resonance” will have on the
resonance.
3-3: Filter 1 SUB
Parameters
Prog.
Edit
P3
To Next Page
Loading...
Need help?
General
