Korg TMR-50 - Advanced Tuning Modes; Tuning to Reference Tone (Sound Out Mode)

17
5. While playing a single note on your
instrument, tune your instrument so that
the tip of the meter indicates “
q” and the
center indicator of the tuning guide is lit up.
The le tuning guide indicator will light
up if the pitch of your instrument is at,
and the right indicator if the pitch is sharp.
If you want to tune a just major third above
or a minor third above a certain note, use the
“ ” (-13.7 cent) or “ ” (+15.6 cent) marks
on the meter.
Tuning to a just major third above or a
minor third above
If you want to tune to a just major third
above A (0 cent), tune your instrument so
that the note name indicator shows C and
the meter is at “
”.
If you want to tune to a minor third above
A (0 cent), tune your instrument so that
the note name indicator shows C and the
meter is at “ ”.
Tuning to a reference tone (Sound Out mode)
1. Press the TUNER ON buon.
You will enter the Meter mode.
2. Press the SOUND buon to select Sound
Out mode.
The reference tone is output from the
PHONES jack or speakers. Use the volume
control to adjust the output volume.
3. Press the CALIB/NOTE p or q buon to
select the note.
The output reference tone changes as
follows.
C (C3) n C
♯
n D n E ♭ n E n F n F
♯
n G n G
♯
n A n B ♭ n B n C (C4) ... C (C6) n C (C3)...
This setting is stored even when the
power is o.
4. Tune the instrument according to the
reference tone.